Four Shower

CHASSIS

• Double axle to carry 2000kg, brake damped tow hitch
• Spring loaded handbrake, 4 no. 13" wheels and tyres
• A-frame welded to chassis
• Tow hitch bolted through A-frame
• Four corner steadies
• Wheel brace included (Spare Wheel Extra)

BODY

• GRP 5 ply board, white high gloss, polished both sides
• All corners supported by polished aluminium angles
• All floor areas are covered with hardwearing fibreglass
• Aluminium around doors and frames
• All doors are self-closing with an airtight seal.
• Yale locks and handles fitted to external doors
• All electrical cables concealed
• Grab handles fitted as standard to all corners
• Appropriate warning signs

INTERNAL SIZES AND FITTINGS

• Clean end: 1950 x 1700 mm
• Shower area: 1620 x 1670 mm
• Dirty End: 1950 x 1450 mm

CLEAN END

• Textured fibreglass covered floor, lower wall and bench
• Lockable sealed external door with vent
• Sixteen personnel lockers
• Mains electric consumer unit, light, bathroom heater
• 2 x 13A charging sockets
• Mirrors and hooks
• Sink with hot and cold water
• Two drain points
• Self-closing door from shower area
• Waste water pump switch

SHOWER AREA

• Fibreglass covered floor and lower walls
• Non-slip matting on floor
• Four individually controlled showers
• Four drain points
• Mirrors and hooks
• Self-closing door from dirty end
• Light
• All pipework concealed

DIRTY END

• Fibreglass covered floor and lower walls
• Removable air extraction unit beneath removable bench
• Mirrors and hooks
• Light
• Two drain points
• Self-closing door from exterior
• Waste water pump switch

HEATING AND PLUMBING

• Two pumped waste water filter systems

All gas appliances are fitted, tested and certified by C.I.T.B. assessed engineers and conform to current Gas Safety Installation and Use Regulations 1994. The gas water heater must be regularly serviced, according to manufacturers' instructions. The unit also comes with an electrical installation certificate issued by a registered NICEIC electrician. Installation and commissioning on site must be carried out by a competent person along with regular safety checks of the unit and any portable appliances according to HSE regulations and/or guidelines.

STANDARD ITEMS FITTED TO THERMAC DECONTAMINATION UNITS

1. 2 Pumped waste water filter systems
2. Plastic plumbing rather than usual copper or chrome
3. Hand wash basin in clean end
4. Removable bench seat over NPU
5. 15m, 240v armoured cable and plug in RCD
6. Propane gas regulator, isolating valves and test points
7. Grab handles fitted to all corners
8. Front marker lights
9. Fresh and waste water hose Pipes (15m)
10. Leg key
11. Two double steps
12. Road lights to current regulations

EXTRA'S AVAILABLE ON THERMAC DECONTAMINATION UNITS

1. Hitch lock (Enclosed Type)
2. Wheel clamp
3. Replacement 5 or 20 micron filter for above
4. Optional 240v power points in clean end
5. Spare wheel and tyre
6. Fire extinguisher 1kg dry powder
7. First aid kit
8. High level side marker lights
9. Lamp guards to protect rear lamp clusters
10. Soap dispensers